Row Offset % – Controls how much each row of boards should be offset.Įxtrude H – Controls the height of the floor.īevel H – Controls the height have the bevel along the edge of the board. Grout Wid – Control the width of the grout in the width direction. ![]() Grout Len – Controls the width of the grout in the length direction. Spread – Controls the distribution if there is variable width, for details read above. Min Width – Controls the minimum length a board can be. Max Width – Controls the maximum width a board can be. Spread – If you have boards with variable length the “Spread” setting will control the distribution between the two sizes, 0,5 the length is evenly distributed, a low Spread value creates a lot of long boards and only a few short ones, a high spread creates a lot of short boards and only a few long ones. ![]() Min Length – Controls the minimum length a board can be. Max Length – Controls the maximum length a board can be.
0 Comments
Leave a Reply. |